Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
GAF Driveway & Pavers: The Orlando Owner’s Guide
We stock and install GAF-compatible driveway and paver systems throughout Orlando, with typical installed pricing running $7,000 to $18,000 depending on square footage, base condition, and paver selection. Most Orlando homeowners discover their driveway or paver failure the same way: after a heavy summer storm, they notice water pooling where it never pooled before, or they spot a paver that’s sunk half an inch below its neighbors. What starts as a trip hazard or a low spot in the driveway is almost always a base failure underneath, not just a surface problem, and that distinction matters when you’re deciding who to call.
If you’re holding a GAF product spec sheet and wondering whether we can match it, the short answer is yes. We work with GAF’s hardscape lines alongside professional-grade paver systems from Belgard, Unilock, and Techo-Bloc, which means we can match your existing layout or rework it entirely. Tell me what the problem is. We’ll figure out the rest from there.
Which GAF Models This Applies To
GAF’s driveway and paver products span several lines, and the compatibility question Orlando homeowners ask us most often is whether they need the exact same paver from the original install or can switch to an equivalent. The honest answer: it depends on the paver’s dimensional profile and the locking system. GAF pavers are manufactured to specific thicknesses, typically 60mm for vehicular applications and 40mm to 50mm for pedestrian patios and walkways. Mixing a 40mm paver into a 60mm driveway will fail, because the thinner paver can’t carry the same load and will crack under vehicle weight.
Identifying your exact GAF paver starts with the underside. Most GAF pavers carry a mold stamp or a small raised code near one corner. If that’s worn off, measure the paver’s thickness and its top dimensions in millimeters, and take a photo in direct sunlight. We can identify most GAF profiles from those two measurements plus the color name. When an exact match isn’t available or has been discontinued, we’ll walk you through the aftermarket equivalent decision: some OEM GAF colors are proprietary and tough to match, while their structural profiles are often shared with industry-standard lines. We’ll tell you which is which before you spend a dollar.
A note on independence: Mason Remodeling Co Orlando is an independent service provider. We’re not affiliated with GAF, and we don’t pretend to be. We install and repair their products because they’re well-engineered, and we stand behind our workmanship separately from any manufacturer warranty.
Styles & brands we work with
Signs Your GAF Driveway & Pavers Is Failing
- Pooling water that lingers more than 30 minutes after rain. This means the slope has been lost, usually because the base material underneath has eroded or settled. In Orlando’s sandy, high-water-table soil, base washout under pavers is the single most common failure we see, especially in older neighborhoods like Conway and Pine Hills where the original base was never compacted to modern standards.
- Pavers that rock or shift when you step on them. A paver that moves underfoot has lost edge restraint or bedding-sand support. You’ll notice it first near the driveway’s edges or where the pavers meet the lawn, because that’s where lateral movement starts.
- Cracks running through individual pavers rather than along the joints. Surface cracks in a driveway-rated paver almost always point to a void in the base directly below that spot. The paver is bridging a gap it was never designed to span, and vehicle weight finishes the job.
- Sinking or a visible dip, especially near the garage apron or a drainage inlet. A low spot of even half an inch means the subgrade has compacted unevenly. Orlando’s afternoon thunderstorms turn a minor dip into a pond, and the repeated wet-dry cycle accelerates the failure.
- Weeds or ants pushing up through the joints in one concentrated area. Joint sand that’s washed out or never installed correctly gives vegetation and insects a highway into your base. Once ants colonize a paver base, they excavate the sand bedding and the surface collapses from underneath.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a full GAF-compatible driveway or paver replacement in Orlando, plan on $7,000 to $18,000 installed. The range is wide because two jobs that look identical from the street can be completely different underneath. A driveway that only needs the top layer of pavers replaced over an intact base sits at the lower end. A full teardown, base excavation, compaction, new bedding sand, edge restraint, and paver installation with a proper slope correction sits at the upper end.
| Scope | Typical Orlando Price Range |
|---|---|
| Paver driveway installation (new) | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Driveway replacement (teardown + rebuild) | $5,000 – $14,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway sealing (surface only) | $250 – $700 |
Every quote we write includes the parts, labor, base work, haul-away of the old material, and a written price before any work starts. That’s not a promotion. It’s how we’ve operated since 2004 as part of the Threshold Group family of home-service companies. We don’t start a job on a verbal estimate, and we don’t send a change order after the pavers are up unless you’ve asked us to add scope. What we install is covered by our 365-Day Done Right Promise: if it’s not right within a year of completion, we make it right at no cost to you.
DIY or Call Us?
There’s one safe thing to do yourself, and that’s document what you’re seeing. Take photos of the failing area from a few angles, note when the problem started, and mark any spots that hold water after rain. Everything beyond documentation is where DIY goes sideways. Paver driveways depend on a compacted base and proper edge restraint, and if you reset a few pavers without fixing the base, you’ll be back in the same spot after the next Florida downpour. Even lifting a single paver without the right tools can chip the edges on adjacent pavers, and now you’ve turned a base problem into a base problem plus a paver-matching problem.
If the issue is a low spot, a cracked paver, or a driveway that’s slowly turning into a wetland, call us at (850) 920-7745. We’ll look at the base, tell you honestly whether it’s a reset or a rebuild, and give you a written price either way.
FAQs
A properly installed paver driveway with a correctly compacted base should last 25 to 30 years in Orlando’s climate, and the pavers themselves can outlast the base. What shortens that lifespan here is water: our summer storm cycle saturates the soil, and any base that wasn’t compacted right will settle within the first three to five years. If your driveway is failing sooner than that, the base is almost always the culprit, not the paver. Call (850) 920-7745 and we’ll confirm what’s actually failing before you spend money on a surface fix.
Yes, if the base under the rest of the driveway is sound. We’ll remove the affected pavers, re-compact the base, add bedding sand, and reset the pavers to match the surrounding grade. If the base failure is widespread, a patch job will keep failing in new spots, and we’ll tell you that plainly before quoting either path.
Most paver driveway replacements in Orlando take three to five working days from teardown to final compaction, depending on square footage and what we find when the old base comes out. If we’re replacing a patio or walkway only, it’s usually two to three days. You’ll have a firm timeline in your written quote before we start, not a vague “about a week.”
We stock common GAF-compatible profiles and standard colors on our service vehicles for small repairs, and Isaac Pruett keeps a working inventory of the most requested Orlando-area paver styles from Belgard, Unilock, and Techo-Bloc. Custom colors and discontinued GAF runs are special-ordered with a lead time we’ll give you up front. We also carry parts for KraftMaid, Cambria, and Silestone when the project calls for it.
Written by Isaac Pruett, Owner, Mason Remodeling Co Orlando at Mason Remodeling Co Orlando, serving Orlando and nearby areas.
