Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Driveway & Pavers: The Orlando Owner’s Guide
ES Windows driveway and paver components in Orlando typically run $7,000 to $18,000 for a full installed system, with most paver driveway replacements landing between $9,000 and $14,000 depending on square footage and the pavers you choose. We stock ES Windows-compatible driveway and paver parts in our Orlando shop and can usually have your replacement scheduled within a few days of your free estimate. Most Orlando homeowners discover a problem the hard way: a paver shifts after a heavy afternoon thunderstorm, water pools where it never pooled before, or the edge restraints that hold everything in place finally let go after years of Florida sun and rain.
If you’re reading this, you’ve probably noticed something that doesn’t look or feel right underfoot, or you’ve got an ES Windows product that needs a matching part and you’re tired of guessing. Tell me what the problem is. We’ll figure out the rest from there.
Which ES Windows Models This Applies To
ES Windows driveway systems in Florida are typically built around interlocking concrete pavers, permeable paver grids, or paver-and-turf combinations. The parts that fail most often aren’t the pavers themselves. They’re the components around them: edge restraints, joint sand, base material, and the occasional cracked paver from a vehicle turning too tight or a tree root pushing up from below.
Here’s the compatibility gotcha most Orlando owners run into: ES Windows driveway pavers come in multiple thicknesses, usually 60mm for residential driveways and 80mm for heavier commercial or RV applications. If you mix thicknesses, even by a quarter inch, your surface will never sit flat and you’ll feel it every time you pull into the garage. We measure every paver we replace against the existing field so the match is exact, not close enough.
For replacement parts, you have two paths: ES Windows-branded components or quality aftermarket equivalents from manufacturers like Belgard and Unilock, both of which we carry. The aftermarket option often saves 15 to 25 percent while delivering the same load rating and color stability. We’ll show you both prices and let you decide. We’re an independent Orlando service provider, not affiliated with ES Windows, so we’re free to recommend the part that actually makes sense for your driveway, not the one a corporate catalog tells us to push.
Styles & brands we work with
Signs Your ES Windows Driveway & Pavers Is Failing
- Pavers shifting or rocking underfoot. This usually means the joint sand has washed out and the pavers no longer lock together. In Orlando, our afternoon downpours accelerate this faster than almost any other climate in the country. A few loose pavers left alone become a wave across the whole driveway.
- Water pooling in low spots after rain. The base material underneath has settled or eroded, which means the subgrade isn’t draining the way it should. Orlando’s sandy soil actually drains well, but only if the base was compacted correctly in the first place.
- Edge restraints pulling away or exposed. The plastic or aluminum edging that holds your driveway’s perimeter has failed or been pushed out by vehicle weight. Once an edge restraint goes, the pavers start migrating outward, and the problem compounds quickly.
- Weeds or grass growing between pavers. That’s a sign the joint sand is gone and organic material has taken its place. In Florida’s growing season, this happens within weeks if the joints aren’t refilled and sealed.
- Visible cracks or spalling on paver surfaces. Direct sun and heat cycles in Orlando are hard on concrete. When pavers start flaking or cracking at the surface, the structural integrity is compromised, and replacement is usually cheaper than repeated patching.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For an ES Windows-compatible driveway paver project in Orlando, you’re looking at these installed ranges:
- Paver driveway installation (full): $7,000 – $18,000
- Driveway replacement (remove and reinstall): $5,000 – $14,000
- Paver patio installation: $3,500 – $11,000
- Driveway sealing: $250 – $700
- Partial paver repair (sections, edges, sunken areas): $800 – $3,000
What drives the price? Square footage is the biggest factor, followed by the paver type you choose, whether the existing base can be salvaged, and access to your driveway. A standard two-car driveway in Orlando runs roughly 400 to 600 square feet. If your base is intact, we can often remove and reset the pavers without rebuilding from scratch, which saves real money.
Every quote we give is a written price before any work starts. That price includes parts, labor, haul-away of old material, and cleanup. No surprise invoices at the end. And every paver driveway project we install in Orlando is covered by our 365-Day Done Right Promise: if the work isn’t right within a year of completion, we make it right at no cost to you.
DIY or Call Us?
Here’s an honest split. There are things you can safely check yourself: whether pavers are rocking, whether water is pooling, whether the edge restraints are visible or buried. You can sweep in new joint sand on a small section. That’s about where safe DIY ends for most Orlando homeowners. The problem is what’s underneath. If your base has settled or washed out, adding sand on top doesn’t fix anything. It just hides the problem for a few months until the next heavy rain.
Paver work also involves moving hundreds of pounds of material. A pallet of pavers weighs over a ton. Improper lifting or base compaction leads to driveways that fail within a year, and then you’re paying twice. We’ve seen enough DIY driveway jobs in Orlando, Altamonte Springs, and Winter Park to know which ones hold up and which ones don’t. The ones that hold up almost always came from a crew that understood Florida drainage. Call (850) 920-7745 for a free estimate and we’ll tell you exactly what your driveway needs, even if the answer is just new joint sand and a good sealing.
FAQs
With proper installation and periodic sealing, concrete pavers in Orlando last 25 to 40 years. The base underneath is what usually fails first, not the pavers themselves. Our Florida sun and heavy seasonal rain shorten the lifespan of joint sand and edge restraints to roughly 5 to 8 years before they need attention. Call (850) 920-7745 if your driveway is showing age and you want an honest assessment.
Yes, in most cases individual pavers or sections can be reset, releveled, and rejointed without replacing the entire driveway. If the base underneath is still stable, repair costs run $800 to $3,000 in Orlando. If the base has failed, spot repairs won’t hold and a full reset makes more sense. We’ll show you what we found underneath before recommending anything.
A typical two-car driveway replacement in Orlando takes 3 to 5 working days from removal to final compaction and joint sand. Partial repairs or edge restraint replacement can often be completed in a single day. Weather can stretch the schedule, since we won’t compact a wet base.
We stock common paver sizes, edge restraints, joint sand, and sealers at our Orlando location, and we keep material partnerships with Belgard and Unilock for full driveway projects. If you need a specific ES Windows part that isn’t on our truck, we can usually source it within a few days. Call (850) 920-7745 with your paver measurements and we’ll tell you what we have on hand.
If your ES Windows driveway is showing signs of failure, or you just want a straight answer about what a repair should cost in Orlando, call (850) 920-7745. We’ll send someone who knows pavers, put the price in writing, and stand behind the work for a full year.
Written by Isaac Pruett, Owner, Mason Remodeling Co Orlando at Mason Remodeling Co Orlando, serving Orlando and nearby areas.
